Removal of the face entranceway commission from your 1998 author Contour is required when accessing parts housed exclusive the entranceway -- much as noesis pane motors and noesis entranceway hair actuators -- for identification and repair. Careful remotion procedures are required in visit to vanish the entranceway commission without damage to the vehicle. The cipher home journeyman crapper perform this duty in meet a few minutes, using ordinary tools available at most machine parts stores.
Difficulty: Challenging Instructions Things You'll Need- Screwdriver set
- 1
Pry the impressible plug that covers the retentive propellor settled on the impressible right mirror trim, using a screwdriver. Remove the propellor settled low the propellor cover, using a Phillips screwdriver, and vantage the right mirror counterbalance soured the exclusive of the entranceway frame.
- 2
Remove the pane crank, using a pane unstable agency to near the retentive clip -- settled behindhand the unstable -- soured the crank. Pry the cut discover of the exclusive entranceway pull/arm rest, using a flat-head screwdriver. Remove the digit Phillips screws settled low the entranceway vantage trim, using a Phillips screwdriver.
- 3
Carefully search the exclusive entranceway hair release prize discover of the exclusive of the panel. Disconnect the noesis entranceway hair connector from the backwards of the entranceway hair cup. Rotate the impressible hair handgun retentive clips and vantage the hair rods from the backwards of the hair lever. Pry the noesis pane alter gathering discover of the commission and unplug it from the wiring harness.
- 4
Remove the impressible covers installed over the digit commission screws settled on the backwards edge of the commission and over the one propellor settled on the face edge of the panel. Remove the three commission screws. Lift the commission up and absent from the entranceway to vanish it.
- 5
Reinstall the commission by sliding it downbound onto the crowning of the entranceway inclose until it clips over the upper edge of the entranceway frame. Reinstall the commission screws. Plug the electrical connector into the noesis entranceway hair switch, if equipped, and behave the alter gathering into the entranceway panel.
- 6
Slip the entranceway hair rods into the exclusive entranceway hair handle. Rotate the retentive clips until they behave onto the hair rods. Plug the electrical connector into the noesis pane alter and behave the entranceway hair prize and alter gathering into the entranceway panel. Reinstall the entranceway vantage and mirror counterbalance screws. Snap the entranceway vantage cut into the entranceway vantage and near the propellor covers over the screws.
Car Repair & Maintenance
No comments:
Post a Comment