How to Change the Air Filter in a 2005 Chrysler Pacifica

ehow.com

When Chrysler released the Pacifica in the 2004 help year, experts saw it as a "segment breaker," as it did not sound in some connatural collection of vehicles. The 2005 Pacifica came accepted with a 210-horsepower, 3.8-liter V-6 engine and had an optional 3.5-liter V-6 that cranked discover 250 horsepower. A separate fortified these engines from bruising contaminants institute in the expose by filtering discover as much detritus as doable prior to the air's incoming in the oxidization chamber. Chrysler recommends replacing the separate every 15,000 to 30,000 miles, depending on dynamical habits. Failure to replace the separate in a opportune manner may lead to poor performance and modify engine damage.

Difficulty: Moderate Instructions things you'll need:

• Phillips screwdriver

• 1

  Open the Pacifica's cowl and post the engine expose separate incase -- the black, impressible incase institute on the driver's lateral of the engine. Trace the expose plaything leading from the expose incase to the engine, then modify the tubing clomp securing the tubing to the engine side, using a Philips screwdriver. Pull the tubing away from the engine.

• 2

  Trace the expose plaything back toward the expose separate incase until you post the intake expose temperature device -- the unaccompanied electrical connector on this tube. Press the protection fix and vantage the wiring command from the IAT sensor.

• 3

  Remove the screws securing the crowning of the expose separate incase to the lowermost of the expose separate box, using a Phillips screwdriver. Pull the crowning of the incase ascending and slide the tabs on the side of the crowning of the expose separate incase from the holes in the lowermost of the expose separate box. Set the crowning of the expose separate incase aside.

• 4

  Grab the separate and vantage it from the lowermost half of the expose separate box; make state of its positioning. Set the newborn expose separate in the expose separate box, in the same position held by the older filter.

• 5

  Line up the tabs on the side of the expose incase crowning with the holes on the side of the expose separate incase bottom, then slide the tabs into the holes. Set the expose separate incase crowning on the expose separate incase lowermost and alter the screws with a Phillips screwdriver.

• 6

  Reconnect the expose plaything to the engine and alter the tubing clamp with a Phillips screwdriver. Plug the IAT device wiring command into the IAT sensor. Close the Pacifica's hood.

Car Repair & Maintenance